RING SIZING
Some rings we can size up 1/2 to a full size, depending on the ring, using a jeweler's ring roller free of charge. If we are unable to size these rings with a jeweler's ring roller the customer can take the ring to a competent jeweler. Please note that inlaid rings normally cannot be sized. Also, note that some rings due to how they are made cannot be sized.

Steps on Measuring:
  1. Wrap a piece of string or paper strip around the base of your finger.
  2. Mark the string or paper where it overlaps to form a complete circle.
  3. Measure the length of the section of string or paper where it overlaps around the finger.
  4. Compare your measurement with this chart to determine your ring size.

RING SIZE INCHES METRIC
4 1 13/16 46.5
4 1/2 1 7/8 47.8
5 1 15/16 49
5 1/2 2 50.3
6 2 1/16 51.5
6 1/2 2 1/8 52.8
7 2 3/16 54
7 1/2 2 1/4 55.3
8 2 5/16 56.6
8 1/2 2 3/8 57.8
9 2 7/16 59.1
9 1/2 2 1/2 60.3
10 2 9/16 61.6
10 1/2 2 5/8 62.8
11 2 11/16 64.1
11 1/2 2 3/4 65.3
12 2 13/16 66.6
12 1/2 2 7/8 67.9
13 2 15/16 69.1


INTERNATIONAL RING SIZE EQUIVALENTS
Canadian& U.S. Inside Diameter
(in millimeters)
United Kingdom Japanese Inside Circumference
(in millimeters)
4 14.8mm H 1/2 7 46.5mm
4 1/2 15.2mm I 1/2 8 48mm
5 15.6mm J 1/2 9 49mm
5 1/2 16mm L 10 50.5mm
6 16.4mm M 12 52mm
6 1/2 16.8mm N 13 53mm
7 17.3mm O 14 54.5mm
7 1/2 17.7mm P 15 55.5mm
8 18.1mm Q 16 57mm
8 1/2 18.5mm Q 1/2 17 58mm
9 18.9mm R 1/2 18 59.5mm
9 1/2 19.3mm S 1/2 20 61mm
10 19.7mm T 1/2 21 62mm
10 1/2 20.1mm U 1/2 22 63.5mm
11 20.6mm V 1/2 24 64.5mm
11 1/2 21mm W 1/2 25 66mm
12 21.4mm Y 26 67.5mm
12 1/2 21.8mm Z 27 68.5mm
13 22.2mm Z +1 28 70mm
13 1/2 22.6mm Z +2 31 72.5mm
14 23mm Z +3 31 72.5mm
14 1/2 23.4mm Z +4 32 74mm
15 23.9mm Z +5 33 75mm


BRACELET OR CUFF SIZING
Follow the same procedure as the ring measurements. The bracelet or cuff will show an inner circumference or diameter and an opening measurement. Just add the two measurements together to get the wrist size. Most, but not all of the bracelets can be slightly adjusted up to 1/2" in or out to fit with the exception of inlay.